Kumo Cloud App Loggin Issues
My Kumo Cloud App is not allowing me to log in. I have tried resetting the password but I am not receiving the reset email. What can I do since I am unable to use the Mitsubishi Electric PAC-USWHS002-WF-2 Wi-Fi Interface?
Mitsubishi Electric PAC-USWHS002-WF-2 Factory Reset
I am having trouble with my PAC-USWHS002-WF-2 interface where the Kumo Cloud app does not find my zone. Where is the factory reset button on this Wi-Fi interface unit?
FJ-IR-WIFI-1NA vs FJ-RC-WIFI-1NA Wi-Fi Adapter Connection
I have 2 indoor units, which I am looking to make Wi-Fi enabled. I am considering FJ-IR-WIFI-1NA and FJ-RC-WIFI-1NA. Do these two have an internal antenna somehow? Also, are they connected next to the existing wall mounted wired control or next to the
Fujitsu AUU9RLF Wi-Fi Control Options
I have a three Fujitsu AUU9RLF ceiling cassettes with a wired wall mounted controller. What parts (Module, etc) do I need to make this older units Wi-Fi controlled?
Carrier 40MBDQ24.3 Unit Remote Access Options
I have a Carrier ducted mini split system and I need to replace the wired wall controller with a wireless controller that I can run from my phone. One of the model I see is #KSACN0701AAA. Is that applicable for what I want to achieve? My indoor unit is
AZAI6WSCDKB Wi-Fi Adapter for Daikin FTX24NMVJU
My indoor unit is FTX24NMVJU. What is the Wi-Fi adaptor that I need to use with this unit?
PAC-USWHS002-WF-2 Compatibility
I have a MFZ-KJ18NA indoor unit with the MHK2 wireless thermostat kit. I would like to use a PAC-USWHS002-WF-2 Wi-Fi kit but would like to get clarification on this note in the compatibility document, "Due to the power requirements of the Wireless Interface
Airzone AZAI6WSPMEL Temperature Unit
Does the Airzone AZAI6WSPMEL support Fahrenheit by default? I have tried other third party CN105 interfaces that do not and it caused issues with setting and viewing the current temperature since it would do an imprecise conversion.
Carrier Mini-Split (DHMAHBQ12XA3) Wi-Fi Control Option
I was informed that the Carrier ductless mini-split which was installed in my house has Wi-Fi capability. The indoor unit model number is #DHMAHBQ12XA3. I have the user manual but am missing the thumb-drive/ dongle needed. If I am able to get one, can
Remote App-Based Control for Mitsubishi Electric MSZ-GL12NA-U1
I want to upgrade my current Mitsubishi Electric MHK1 with an app-based remote control. Is there any option that is compatible with my MSZ-GL12NA-U1 indoor unit? Also, can the available option work with MHK1 thermostat?
Fujitsu Halcyon Unit Wi-Fi Control Options (ASU30RLX)
I have a Fujitsu ASU30RLX Halcyon unit. No remotes are working perfectly for me. I am trying to explore options to make it remotely accessible. Will the FJ-IR-WIFI-1NA wireless interface be able to connect to it? My primary goal is to access the unit
PAC-USWHS002-WF-2 Compatibility with Archer AX21 Router
Hi y'all. I would like to know whether PAC-USWHS002-WF-2 is compatible with Archer AX21 router.
Controlling one Indoor Unit using MHK2 and PAC-USWHS002-WF-2
I have 3 zones so I would need to install one of these PAC-USWHS002-WF-2 (https://shop.rfwel.com/mitsubishi-electric-pac-uswhs002-wf-2-wireless-wi-fi-interface-control-2/) per zone, is that right? Also will using this affect my control using MRCH2?
Mitsubishi Electric PAC-USWHS002-WF-2 WPS Connection
Not sure of how to set up the Kumo Cloud PAC-USWHS002-WF-2. I am watching a video that shows it connects to the network via WPS. Is that the only way? I don't have WPS on my router.
Aidoo Wi-Fi to Daikin Sky Air or VRV
Hello, I need assistance with some guidance on how to integrate my Aidoo Wi-Fi to my VRV Daikin unit.
Airzone connection/assembly for Fujitsu 3 wire cases
How do I do connection for Aidoo Wi-Fi adapter for a Fujitsu unit with 3 wire protocol? Do I need to maintain the the thermostat controller?
PAR-SA9FA-E Vs PAR-SE9FA-E Corner Panel Receiver
I have seen the PAR-SA9FA-E (https://shop.rfwel.com/mitsubishi-par-sa9fa-e-p-series-signal-receiver/) which looks somehow like the PAR-SE9FA-E Corner Panel Receiver which I need for my units. My unit is PLFY-P50VEM-E. Should it be able to work?
FJ-RC-WIFI-1NA Communication Error with Fujitsu System
I have set up Fujitsu FJ-RC-WIFI-1NA Wi-Fi Module for use with my #AUU12RLF unit. However, I am getting an error; Error IH1: Error in the communication of IntesisHome device with the AC unit. I have already checked the compatibility table, so compatibility
Issues Connecting FJ-IR-WIFI-1NA to Starlink Router
I own model FJ-IR-WIFI-1NA and am having an issue connecting to my Starlink router's Wi-Fi. I get the yellow and green blinking lights, unknown error, also green and red flashing LEDs. It is working fine with my Netgear Extender. Any suggestions?
Mitsubishi PAC-USWHS002-WF-2 Wireless Interface 2 Alexa/ GoogleHome Compatibility
Is it possible for me to substitute the PAR-SA9CA-E receivers currently installed in my home with newer options that offer cloud connectivity and compatibility with Alexa/Google Home? I have already connected all the other split units using their embedded
Application for Airzone AZAI6WSPMEL Cloud Wi-Fi Adapter for Mitsubishi Electric Units.
We have MHK2 remotes for our mini-split. If we installed this, would we still be able to use them to control it? Or if we wanted to switch to a smart thermostat like an Ecobee, would this be compatible with that?
Mitsubishi Wireless Interface 2 (PAC-USWHS002-WF-2) Wi-Fi Communication Issue
Hi all, my Mitsubishi Kumo Cloud Interface does not communicate with the Wi-Fi router. I have tried out troubleshooting including installing a new router but I still get the error message that Kumo Cloud does not connect to the router. Can any specialists
Fixing Mitsubishi Wireless Interface 2 (PAC-USWHS002-WF-2) Connection Problem
Hello Pro HVAC'ers! My Kumo Cloud Wireless Interface PAC-USWHS002-WF-2 like the one in the link here (https://shop.rfwel.com/mitsubishi-electric-pac-uswhs002-wf-2-wireless-wi-fi-interface-control-2/) has a problem. LEDs don't light on anymore. They were