120V Photocell Power Tap with Dimming Control
I am interested in Ripley Lighting Controls #5731-20-1 or any other 120V Photocell Power Tap which retains dimming vontrol. Will the power to my appliance turn off at daylight?
FP289A-120-CNB-A 7-pin power tap vs FP289A-120-CNB 3-pin power tap
Can I use a 7-pin power tap instead of a 3-pin power tap? Does the 7-pin work well ignoring the control pass through pins?
POE output voltages
I have a Netgear switch supporting POE (IEEE 802.3at) on 8 ports. I am unclear on the output voltage levels, is it 48V or 56/57 V? The datasheet clearly shows the power is 30W, but what is the voltage? Seen several unclear and conflicting responses online.
step-down photocell power taps
For a unit that steps down voltage from 480 to 120VAC, would it supply power to my 110 VAC battery charging system without faults? what is the output range?
No Control Pass Through
For streetlight power taps, can you please explain the 3- pin (no control pass-through). Does that mean that we can not plug a photo cell back on top on this unit to control the street light?
PHTCELTAP alternatives
Hi, we are looking to use photocell power adapter tap ( SKU:PHTCELTAP) for our project. Quick question regarding electrical specification, the input voltage range is 90-480V and output voltage is 120VAC. Does that mean if we install the power tap on 480V
Cable Lengths
For PHTCELTAP photocell bypass adapters, what's the maximum length of cable I can add as an extension to the 10 ft cable it came with. I know it comes with the 16 AWG cable, but i want to add a 14 AWG cable. What are the possibilities?
Zhaga 18 and ANSI C136.10
I have been seeing a lot of conversation on the Zhaga (Book 18 Standard) being a replacement for the NEMA ANSI C136.10 receptacles. What's the possibility and what would be the fate of installations the C136.10 standard luminaires, photocontrols and power
Normal photocontrol Operation
For the PHTCELTAP light pole tap, I just want to make sure, after installing this unit between (3-pin) twistlock photocell and light fixture, would photocell still function as normal, for example, turn lights on at dusk and off at dawn?
Power Tap Grounding
For any of these, do we have a model with ground connection? Meaning could I have a hot, neutral and ground? I cant seem to find or confirm the presence of grounding in some units like the FP285A. Is the grounding receptacle shown in the image "fake"?
3 Pin Mini-Link Power Taps
For the following units, what is the terminal allocation for the 3 pins?
FP289A-120-CNB step down light pole tap
For your streetlight power tap adapters like the step down (FP289A-120-CNB), what is the warranty and what type of technical support is available to installers or maintenance personnel? What safety features are available to protect against electrical
Zhaga 18 Compatibility
Hello, For the Zhaga Book 18(ANSI C136.58) receptacles, can we have light pole taps like those found here: https://shop.rfwel.com/power-tap/
POE power taps
We're looking for a photocell power tap to convert 480vac to POE (48vdc) for a Cisco access point. I saw this FP287A-120-ADN-A, but it only works with 120vac. Can anyone share if there are singular and complete units that can do this for 480vac?
Cisco AIR-PWR-ST-LT-R3P
I have asked this question in a couple of forums with no response. For this specific streetlight power tap from Cisco (AIR-PWR-ST-LT-R3P), what is its actual voltage output. From the manual it is rated for 100-277V AC operation, does this mean it will
stepped-down power for APs
I have some cisco 1570 access points that I want installed outside, I have a couple of AIR-PWR-ST-LT-R3P to tap the light from the pole (not enough though). The 4 ft. cable is quite short for the position I want the unit at, could you recommend a unit
Streetlight Power Taps
What do you mean when you say your power taps retain dimming control?